SUNLU AMS Heater, Compatible with Bambu lab AMS Gen 1

This was easy to install and works really well. My print quality is coming out much better now that I am able to dry my filament. I also love that I can dry while printing! Huge bonus! Planning on buying a second one for my other printer!

I was very hesitant to purchase this SUNSLU AMS Heater for my Bambu Lab Gen1 AMS; but when I got a notification of a big discount on it, I went ahead and got it.A REAL GOOD INVESTMENT !!! Very convenient to just turn-on and let it cycle for the time/filament you set. I normally keep the SAME TYPE of filaments on the AMS, as I use PETG like 90% of the time, so it's EASY and CONVENIENT to cycle-on a couple of times x week to keep filaments at optimum levels, ready-to-print.

Works well on my Bambu P1S AMS super easy to install and use.After using it for around 3 weeks I have had no issues with any clogging or brittleness.So far its been a great investment for my 3D printer. I will be buying again when I purchase another P1S

Must-have add-on for my P1S, worked great with the AMS and it's improving my prints quality like it's unbelievable. It's so easy to setup and use as well. Doesn't make your printer look bulkier, in fact it makes it look better in my opinion.

I am not the most technical so at first taking apart the Bambu AMS was a bit stressful at first. Found a video to help walk me through it. The SUNLU AMS Heater went on easier than the original lid came off. We bought this to help keep more 'blobs of death' from happening. We have run this about once a week. Will likely have to ramp that up as we go into summer and humidity season.We have had no major issues with wet filament clogging up or printing properly now that we have started using this heater. The device itself works fine. We have forgotten at times to move the slide at the top to the c

Bought for my ams. Wow! Super easy install. It looks great on the printer and it works amazingly well. I can dry 4 rolls and print at the same time. I wish the vent was automatic and would open/close on its own but I’m sure that would add to the already amazing price. Some people complained about noise, maybe if it’s in your bedroom. Otherwise it’s quiet enough. Get one. You won’t be disappointed.

After testing it for months in one AMS, I decided to pick up a second one since I'm very happy with the results. I don't burn through tons of filament like some, but I want the machine to print properly when I need it. If you don't enjoy fiddling with filament and just want your machine to be ready to print, this is an excellent little unit, but there are a few things you should know. 1: The AMS built-in humidity sensors really won't work well anymore. They don't seem to adapt to the changing heat inside the enclosure and will give false readings that wander all over depending on dryer temps.

I’m on the fence about this one at the moment. I did want a heater/dryer that works with my AMS this seemed to check the boxes for what I want.The install was pretty easy and it seems to fit the AMS fairly well. Operation is where I’m leery.I had an existing temp/humidity sensor in my AMS and I noticed that the heater and the existing sensor differed so I decided to do some tests.On the PLA setting, it ramps up to and holds at 50°c via the pre-installed profile. I let it run, as instructed, for about 4 hours before I checked the temp and relative humidity levels. The display on the heater read