BTECH RPS-30PRO 30 Amp Regulated Universal Compact Bench Power Supply, AC-to-DC Power Convertor, 13.8V (9~15VDC Adjustable) with Noise Offset Adjustment, Includes Multiple Power Connections

I purchased this Btech powersupply because it was very reasonable/low cost as compared to other manufacturers. Prices on powersupplies have gone up a lot, but Btech has the cost within the range I needed. In addition, Btech has a good reputation on radio and power supplies.I use this on my FT-710 and an external tuner.Have not had any issues at all. Delivers a solid 13.8 volts. Voltage can be adjustable, of preset to 13.8 volts (via a switch in the rear). Power to my FT-710 is clean and no noise or buzzing. I usually drive about 6 amps from this powersupply.Happy with this product. Does what i

Solid power supply so far! More than enough power to drive my btech 50 W gmrs base station. No noticeable noise output in received or transmitted signals. Voltage regulation is dead on. There are cheaper supplies available, but I like the build quality and performance on this one. No regrets at this point.

Works well for powering my Radios, for the price point. Was easy to install in place of the previous Power Supply.

I bought the BTECH RPS-30Pro 30A power supply so that I can test various HAM, GPRS, CB and LMR radios. The picture below shows an Alinco DR-135 key down on medium power drawing around 8A. I needed to make a 1/4" ring terminal to Anderson Power Pole cable to power most radios that have APP connectors like the one shown in the photo.The 30A supply runs on 120VAC using a supplied grounded C-13 lab cord (the defacto standard). The 8A AC fuse appears to be internal to the supply.Operation is easy: connect the device under test, switch in back to 13.8v (instead of variable) and turn the power supply

I bought this power supply for powering HAM radios which is its intended use.It has three options for connecting loads:* Banana plug/wire terminals on the back (30A)* Car cigarette lighter style socket on the front (10A)* Cable clamps on the front (3A)It has the option to switch the output voltage between a fixed 13.8V (which is 1.2V higher as the nominal output voltage of a 12V vehicle battery or similar) and a variable output voltage between roughly 8V and 15V (the switch for toggling between the fixed and variable voltage output is on the back panel, which is not a bad thing as it should pr

Works great. Runs 100 watts on ICOM 7300. Quiet. Runs cool.

Had it over a year still works