Consew CSM3000 Sewing Machine Electric Servo Motor, 110 Volt, 1HP, 750W

Exceeds my expectations greatly! Studied as much info as I could find about sewing servos and decided to give the 750w version a try. I am using this on wood lathe to replace a single speed induction motor and am very satisfied. I feared this motor would slow down under heavy load but it has plenty of torque and the speed controller compensates to maintain the selected rpm even down at the initial motor start speed shown as 100 rpm. I can hear the motor speed fluctuate for fraction of a second and only slightly when placed under load but motor compensates immediately and does not affect cuts.

Overview: Best upgrade you can do! Don't buy the smaller motor, get the 1HP 750W motor!Bought this after getting sick of dealing with the original clutch motor. Installation on my old Consew 226 wasn't difficult, but I did need to drill new mounting holes on the table which was the most difficult part. Getting the pulleys lined up and drilling the holes took a lot of careful measuring. I also had to recess the mounting bolts a tad on top to get the length I needed to get through my wood table top. Youtube videos of similar installs helped get it all together correctly.Once installed It has bee

I replaced my old original 111W Singer clutch motor, with this CSM3000 servo motor. I have used my old industrial singer for 35 years, so I had learned to control the old clutch motor pretty well. This new powerful servo motor made sewing a whole new ballgame. I am able to control the speed at startup now without touching the handwheel ! No more background hum, just silence until I step on the pedal. On a safety note I plugged my sewing light into the new controllers one receptacle outlet and the light turns on and off with the motor. So when changing bobbins or replacing a needle I know that

Very easy install and much better than the old clutch motor. May still get a 40 mm pulley to replace the 75 for even more control. Everything looks good and is functioning as described. Pedal action is very lite and much less travel than before. Watch YouTube installs as they are much clearer than the instructions.

Excellent product will buy another one soon Great quality and improve my control on my machine thank you

This fit a Consew 226 on a standard industrial sewing table. Yes, you'll need to be handy with tools. And you'll probably need a different sized motor drive belt, which I also got from Amazon very quickly. But count on the machine being down until a new one comes in. Unfortunately, I don't know of any way to estimate the new belt size until the motor unit is mounted. Mount, measure, and order a new properly sized belt.This motor really slows down the needle speed when needed, but still allows full speed sewing when needed. Recommended.

Installed this on my Singer 211G157 replacing an industrial clutch motor that weighs a ton. Installing this system decreased the total weight of the machine and table significantly. For the record I'm not a seasoned pro, more like a very green beginner when it comes to sewing I know just enough to be dangerous. That being said the installation was pretty straight forward. Pay close attention to the diagram and you should be ok. The speed setting was also easy following the provided instructions. I was able to sew a costume and not have to worry about it going 100MPH in a flash. Getting a needl

I am new to industrial sewing machines, but I already knew there was no way I will ever sew at 2,000 SPM, so I ordered this Consew servo motor. And I didn't want to spend an additional $130 on a speed reducer, to slow it down even more, so I opted for an $8, 45mm pulley, to replace the 75mm that comes on the motor. I never ran the motor with the original pulley, but I can slow it down to 1 stitch at a time with the 45mm pulley on there.I researched servo motors before I bought this one, I decided on the 750W because it had a programable digital controller on it. As for the instructions on how